| Capacity Air Conditioner 5.5 HP | Type | Refrigerant Gas R410A |
| Specifications | ||
| Made in | : | Brand: Japan - Made in: Thailand |
| Refrigerant | : | R410A |
| Type | : | Mono |
| Cooling Capacity | : | 5.5 Hp - 14.5 kW |
| Use For Room | : | Area 77 - 80 m² or 231 - 240 m³ (suitable for office living room) |
| Power Input (Ph/V/Hz) | : | 3 Phase, 380 - 415 V, 50Hz |
| Power consumption (kW) | : | 4.5 kW |
| Refrigerant/ Liquid Pipe Diameter (mm) | : | 9.52 / 15.88 |
| Maximum Pipe Length | : | 50 m |
| Maximum Elevation Length | : | 30 m |
| Indoor Unit | ||
| Indoor Unit Model | : | FDT140CSV-S5 |
| Indoor Unit Dimensions (mm) | : | 298 x 840 x 840 mm |
| Indoor Unit Net Weight (Kg) | : | 25 kg |
| Panel | ||
| Panel Dimensions (mm) | : | 35 x 950 x 950 mm |
| Panel Net Weight (Kg) | : | 5 kg |
| Outdoor Unit | ||
| Outdoor Unit Model | : | FDC140CSV-S5 |
| Outdoor Unit Dimensions (mm) | : | 1300 x 970 x 370 |
| Outdoor Unit Net Weight (Kg) | : | 106 kg |
Check that the access doors have removable corner covers to install the indoor unit without removing the panel. It also makes it easier to service and install.
Remove the corner cap to check. The new design allows checking the water pump without removing the panel. Locating the water trough's drain hole is also simple.
The drain pump is pre-installed with an 850mm pipe lift to facilitate pipe routing. Installation is also made simple by a 185mm soft tube, a standard accessory, and a location.
The wired controller can control the flaps from high to low independently. (This control system also works on FDE ceilings.)
*The remote controller or the RCH-E3 applies no flap control.
Feedback
